What should be done for the inspection and maintenance of a single arm hydraulic press?

The inspection of a single arm hydraulic press includes external overall inspection, clutch device inspection, trial operation inspection, forging part inspection and adjustment, and input device inspection.

External overall inspection: Clean the exterior of the machine tool and check if the screws are loose, cracked, or deformed. The length of the logo on the fuselage cannot be less than 30cm;

Inspection of clutch device: The inspection of the clutch should be carried out during operation to check the wear of the wavy teeth. If one-third of them are worn off, they need to be replaced;

Test run inspection: After the machine tool rotates, we need to check for any air leaks, abnormal vibrations, and lubrication;

Inspection and adjustment of forging parts: When conducting pressure tests, we can use relatively high pressure to detect the stroke of the piston. There should be no leakage in the oil circuit. After removing all the pressure, the pressure gauge will return to 0, and at this time, the parts are not damaged;

Inspection of input devices: The conveyor chain should be checked one by one, and if there are serious wear, deformation, etc., we need to replace them. The tension of the chain should be the same, with the chain length being able to touch slightly.